This HAITIAN MA900 II eco was manufactured in 2016. It is a hydraulic injection moulding machine with a clamping force of 900kN and a shot volume of 153 cm3. Consider the opportunity to buy this HAITIAN MA900 II eco hydraulic injection moulding machine. Contact us for more information.
Location: DE
Screw Diameter: 36 mm
Injection Capacity (PS): 139 g
Plasticization Capacity: 13.3 g/s
Heating power: 7. 85 kw
Tie-bar spacing (hxv): 360 × 360 mm
Die-height available: 150 – 380 mm
Ejector number: 5
Pump motor power: 11 kw
Minimum mold size (l×w): 250 × 250 mm
Required Installation Space: Should allow at least 1 m clearance around the machine for operation and maintenance
Foundation Type: Reinforced concrete foundation recommended
Load-bearing Capacity: Must support ≥ 3.5 t machine weight
Level Tolerance: Machine must be installed on a level foundation (≤ 0.2 mm/m slope)
Vibration Damping: Use anti-vibration pads or steel plates under machine feet
Pump Motor Power: 11 kW
Heating Power: 7.85 kW
Total Installed Power (approx.): ~19 kW
Power Supply: 3-phase, typically 400V / 50Hz (check local spec)
Circuit Breaker Recommendation: ≥ 40 A (depends on local standards)
Grounding: Reliable grounding required (≤ 4 Ω resistance)
Cable Suspension Diagram: Machine must be leveled before connecting cables
Oil Tank Capacity: 190 L (use recommended hydraulic oil ISO VG46)
Water Quality: Clean, non-corrosive, filtered
Water Pressure: 0.2 – 0.4 MPa
Ambient Temperature: 5 – 40 °C
Relative Humidity: ≤ 90% (non-condensing)
Installation Location: Indoor, vibration-free, dust-free environment
Machine Foundation & Mat Diagram
Cable & Electrical Requirements
Cooling & Hydraulic Requirements
Cooling Water Requirement
For Hydraulic Oil Cooler
For Mold Cooling Circuits (4 × water passages provided)
Environmental Conditions